Logo

B1A10 Engine Trouble Code

Meaning of B1A10 engine trouble code is a kind of body trouble code and when the check engine light comes B1A10 code on the first you should check is the gas cap. Pull over, retighten it, and take a look at the cap to see if it has any cracks in it. Continue driving and see if the check engine light turns off. Alternately, you can purchase a gas cap for about $3 at an auto parts store. All you need to do is take the old one off and screw on the new one. If you've already made it to the store, you might as well just replace it. While not car-threatening, it's good to take care of this right away to improve gas mileage.

B1A10 Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting
If one of these reasons for B1A10 code is occuring now you should check B1A10 repair processes.
Now don't ask yourself; What should you do with B1A10 code ?
The solution is here :

B1A10 Possible Solution:

B1A10 Engine

Power Steering Pressure (PSP) Switch Malfunction In Key On, Engine Off Self-Test, this DTC indicates the PSP input to the PCM is high. In Key On, Engine Running Self-Test, this DTC indicates that the PSP input did not change state. Steering wheel must be turned during Key On, Engine Running Self-Test PSP switch/shorting bar damaged SIG RTN circuit open PSP circuit open or shorted to SIGRTN PCM damaged.

B1A10 Code Meaning :

B 1 a 1 0
OBD-II Diagnostic Body (B) Trouble Code For Engine Fuel And Air Metering Engine Shutoff Solenoid Malfunction Shift Solenoid E Performance or Stuck Off

The oxygen (02) sensors on your car measure the oxygen in the exhaust to determine how rich or lean the ratio of fuel and air are in the cylinders. Optimizing this mixture means better fuel economy and fewer exhaust emissions.

B1A10 OBD-II Diagnostic Body (B) Trouble Code Description

B1A10 engine trouble code is about Shift Solenoid E Performance or Stuck Off.

Main reason For B1A10 Code

The reason of B1A10 OBD-II Engine Trouble Code is .

B1A10 DTC reports a sensor fault, replacement of the sensor is unlikely to resolve the underlying problem. The fault is most likely to be caused by the systems that the sensor is monitoring, but might even be caused by the wiring to the sensor itself.